Note on regions: - HINT: Exported values for the regions are binary coded: 1=AO, 8=PO, 16=IO, 4=AMS, thus 5=1+4=AO+AMS, 25 would be 1+8+16=AO+PO+IO... (SO has been dismissed!)
Note on adjustments: - Your Expocode is not listed? Please check adjustments table by filtering your Expocode and review result set!
- -999=Not available | -888=Not considered | -777=Poor data, no adjustment suggested | -666=Inclusion postponed (No objective statement about data quality can be given at this point)
- DISMISSED!: If one of the three carbon parameters TCO2, alkalinity or pH is calculated, this one is marked red and annotated as e.g. -0.123456c!
- Actions (act.) taken for (CTD) salinity calibration: 7="using BOTsal because bad fit of CTDsal."; 6="using mean of BOTsal and fitted CTDsal."; 5="using mean of BOTsal and UNCHANGED CTDsal."; 4="using BOTsal (few or no CTDsal or BOTsal>80%)."; 3="using BOTsal (no CTDsal)"; 2="using CTDsal (no BOTsal)"; 1="using none"
- Actions (act.) taken for (CTD) oxygen calibration: 7="using BOToxy because bad fit of CTDoxy."; 6="using mean of BOToxy and fitted CTDoxy."; 5="using mean of BOToxy and UNCHANGED CTDoxy."; 4="using BOToxy (few or no CTDoxy or BOToxy>80%)."; 3="using BOToxy (no CTDoxy)"; 2="using CTDoxy (no BOToxy)"; 1="using none"
- To calibrate CTDsal use: CTDsal_calibrated = (CTDsal - CTDsal_intercept) / CTDsal_slope
- To calibrate CTDoxy use: CTDoxy_calibrated = (CTDoxy - CTDoxy_intercept) / CTDoxy_slope
- Adjustment flags: 2=good | 3=poor | -999=Not available